Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Seat Cut Rafters
[ 4 Answers ]
I'm building a garage and want to use 2 x 6 rafters gable roof. How do I figure the length of the rafters and the angle of the plum and seat cut? I'm just pouring the slab. Then I'll build the walls and then the rafters, decking and composition roof. The span will be 20 feet and the rise I guess...
Whirlpool Front Load Dryer Will Not Start
[ 0 Answers ]
I have a Whirlpool front load dryer. We have had a power failure at the house during a time that the dryer was operating. We have replaced the circuit that blew, but my dryer will not turn on now. I have the same washer and it works, but the dryer will not. I have tried unplugging it and...
On Trane XE 60, how to remove front cover and start pilot light?
[ 1 Answers ]
This is a Trane XE 60 unit, model TUP080B936A with a standing pilot. Our heat did no go on this morning. I turned the circuit breaker off. 1. How do I remove the front panel? 2. Will the location of the pilot light be obvious? 3. Should the pilot light still be on or would it have been...
Front facing car seat?
[ 10 Answers ]
I'm not sure if this is the right section for this. My daughter is about 14 and 1/2 months old. She's only 18 lbs. 3 oz. and about 30 inches tall. I still have her in the rear facing infant carseat cause she's supposed to be a year old AND at least 20 lbs. to go into a forward facing booster... View more questions Search
|