Ask Experts Questions for FREE Help !
Ask
    OLIN123's Avatar
    OLIN123 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 4, 2009, 09:31 AM
    No power on furnace
    Is there a reset button on a westinghouse (nordyne) 80+ afue?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Aug 4, 2009, 10:58 AM
    I doubt it have you checked breakers if so, did /can you check transformer for 24 volts output?
    On a gas furnace most have to have the doors/cover firmly installed for the power to be activated
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace electrical power failed [ 2 Answers ]

I have a westinghouse gas furnace (nordyne) 80+ afue 5 years old. We have had a power outage and subsequently lost power to a water pump plugged into an outlet on furnace. The pump is good. The outlet is good. The breaker is good. Is there a reset button on the unit and if so where is it located....

Only furnace blower goes on at power up. [ 6 Answers ]

I have a Tempstar Furnace Model NUG5100 BFB2 installed in 1995 I think. When you power up the unit the furnace fan comes on and that is all. Have checked thermo, changed to another, replaced furnace module(fan timer control) and still only the fan will blow. Help if you please.

How can I imcrease the blowing power of my furnace? [ 1 Answers ]

I have a gas fueled forced air furnace. Upstairs get warm, but downstairs doesn't. The air from the vents is very weak; it trickles air instead of blowing it. The pipe that goes to the chimney gets really hot and the heating duct by the furnace is warm by the furnace, but the further away from the...

No power in my Intertherm furnace [ 2 Answers ]

Greetings, I have an Intertherm M2RC furnace running on LP. I tried to start it up a couple of weeks ago, it ran for a second then quit. The furnace is getting power, but the red LED indicator light is not lighting. With cold weather just a couple of weeks out, I could use some help. Thanks

Trance A/C w/ Furnace - No Power - Help [ 1 Answers ]

Please Help! Trane XB1000 - A/C w/ Natural Gas Furnace Mfg. Date 04/96 I recently moved to a new home that has an A/C w/ furnace for the downstairs. It has been running just fine until yesterday. It was working in the AM, I set the thermostat lower to shut off and left it alone. I went to...

View more questions Search