 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
New Toilet?
The Toilet Is Bubbling And Doesn't Flush Strong.
You don't need a new toilet. You have a partial blockage on down the line. Let me explain. You flush or drain a fixture and the discharge runs down the drain, hits the partial clog and bounces back sending a bubble of air ahead of it. Then it drains away but not before it impedes the flush. The solution is to snake the line out from the lavatory roof vent. Put out enough cable to get to the base of the vent and about 20 feet more. Good luck, Tom |
||||
|
||||
|
The Toilet Is Bubbling And Doesn't Flush Strong.
You don't need a new toilet. You have a partial blockage on down the line. Let me explain. You flush or drain a fixture and the discharge runs down the drain, hits the partial clog and bounces back sending a bubble of air ahead of it. Then it drains away but not before it impedes the flush. The solution is to snake the line out from the lavatory roof vent. Put out enough cable to get to the base of the vent and about 20 feet more. Good luck, Tom |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi, I have a confusing problem.I just installed a new toilet in place of an existing one. The promblem is when I flush the new toto toilet, my other toilet bowl almost completely empties.. The 2 toilets are basically back to back, and use the same vent pipe through the roof.(3 inch copper).No pipes...
My toilet does not flush properly, it needs to be flushed 2 or 3 times. I've changed all the parts in the tank but still get the same results, what do I do?
I have a 2 storey layout house. The guest restroom on the ground floor is exactly below the Jack and Jill Washroom of the top floor. It looks in both the restrooms the toilets share the pipe line The problem is when someone goes to restroom on the ground floor , the top floor toilet gets...
I'v been dealing with this plumbing thing for about 6 months or so and I still can't get it just right. I bought a new flapper about 6 months ago and I've been adjusting it on & off every since and now the flapper is being sucked into the hole causing my water to continue to run. Could you please...
I started smelling sewage in my basement bathroom, and when I looked in the toilet, it had no water in it(none on the floor) It was used the previous day. When I flushed it, it seemed to be normal and stay at the correct level. I came back and checked about a half hour later and still seemed fine. ...
View more questions Search
|
