Ask Experts Questions for FREE Help !
Ask
    stevenaw's Avatar
    stevenaw Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 31, 2009, 08:04 AM
    No pressure
    I have no water pressure into my home just replaced pump last year. I had pressure yesterday
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Jul 31, 2009, 08:27 AM

    1. Check the breaker. Has it been tripped?
    2. If breaker is good, then pull the cover off the grey switch. Are the points closed or open?
    3. Check the pressure gauge. Probably it reads zero, but stranger things have happened.
    4. Do you have a water softener or filter? If so, and if the three things above looked good, then use the bypass valve on the filter/softener.

    Get back with your results.
    BTW, is your pump above ground or in the well?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cold water pressure is lower than Hotwater pressure [ 1 Answers ]

In the bathroom sink, I see the hotwater pressure is very good . When I open the cold water it is very low. It is was fine 2 weeks ago. What could be the problem? Thanks Asaad

Pressure tank won't hold pressure only 20psi [ 7 Answers ]

Hi, I am lost at what to do. Early this week when running water, especially the shower after a few minutes the water pressure would go way down. After letting it off and let it sit the pressure would come back but only for a short time. Got worse as the week went on until we never got...

Deep well, pressure tank/switch not building pressure [ 13 Answers ]

The only way I have water pressure is to leave the power on! I have replaced the 5 gallon pressure tank (28psi when void of water)/fittings/pressure gauge and tried 3 new 30/50 pressure switches and the problem remains the same. With the power off, the pressure drops to 0 (not 30). When I...

Low water pressure causing high blood pressure [ 1 Answers ]

I have low or no hot water pressure to the downstairs bathroom. I've replaced the cartridges, valves and hot water heater, still no pressure... help.

Do you add 30 410a freon pressure like you do r22 and r12 for high side pressure in c [ 1 Answers ]

Do you have to add 30 to the ambeint air temp. like you do for r22 and r12 to R410a freon to get the proper high side pressure reading

View more questions Search