Ask Experts Questions for FREE Help !
Ask
    leeannmerrill's Avatar
    leeannmerrill Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 29, 2009, 08:02 AM
    Furnace fan won't turn on
    I have a Rheem Criterion II furnace and a Honeywell thermostat has an "on" switch for the fan. The company that services my furnace said if I turned tha switch to on and a separate "system" switch to off, the fan would turn on. It doesn't. Is my furnace able to turn on just the fan? If so, how do I do it?
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
     
    #2

    Jul 29, 2009, 09:57 AM

    Do you have an Air Conditioning system connected to your heating system?
    siberianair's Avatar
    siberianair Posts: 360, Reputation: -4
    Full Member
     
    #3

    Jul 29, 2009, 02:29 PM

    They told you correctly.. might not be wired correctly or you might have a problem with control board or relay.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace does not turn on [ 4 Answers ]

I have had the furnace off and we recently had a huge thunderstorm with hail, etc. A few of my circuit breaker had tripped but the Furnace wasn't one of them. I tried to turn the heater on and the thermostat does say heating. But I never hear the blower turn on. I go up to the attic and sure...

Furnace will not turn on [ 1 Answers ]

I have a Goodman furnace that we just replaced the vent motor on. It worked fine for about 2 hours and then it came on but would not ignite. The fan comes on and several seconds later you hear a click but the ignitor does not glow. I sucked on the line going to the pressure switch and it seems...

Gas Furnace Won't Turn On [ 1 Answers ]

We have a Lux gas furnace that isn't working right. We woke up to a much colder house than we had planned. We've reset the thermostat several times and tried several configurations to no avail. We finally heard the heater kick on when we switched the fan button from "auto" to "on". This made...

NG Furnace will not turn on [ 2 Answers ]

Make: RHEEM Model: RGDO 06NC ER Installed: 1990 Problem: Observe glow in burner area from ignitor but the gas won't turn on. After a few seconds the glow will turn off. The Hot Surface Ignition Module was replaced in 1997. Please advise.


View more questions Search