Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
York Diamond 80 heat blower cycles 20 seconds
[ 9 Answers ]
Hi, I have a 1996 York Diamond 80 furnace. Everything starts up OK (thermostat fine, flue fan kicks on fine, then pilot orange glow, then click, then gas burners fire up, then main blower fan starts). This all happens in about a minute or so, but then the main fan only runs for 22 seconds, then it...
Goodman GMPN060-3 Blower Cycles
[ 2 Answers ]
I have been in my house for 5 years when the thermostat calls for heat, the inducer blower comes on and almost immediately I hear the pressure switch click and then the relay on the main board clicks and the inducer blower goes off. This happens over and over for a couple of minutes and finally...
Ac blower cycles on/off at start
[ 4 Answers ]
When the outside temp closes in on the thermostat set temp ( at night ) the ac will cycle on but the blower will try to start then turn off. It cycles like this for a number of times before finally overcoming the issue and then it will run normally. If during this cycling I move the thermostat to...
Heatpump blower cycles on off
[ 1 Answers ]
The heatpump works but the blower has problems. When the fan is put to "On", or when the system is initiated by the thermostat, the blower sometimes will try to start, but cycles on/off. I can hear the relay clicking. When the system does operate correctly the problem will eventually re-occur....
Furnace blower cycles with Thermostat off
[ 2 Answers ]
Have Goodman Furnace built 1994. Worked fine until about 3 weeks ago. It starts cycling, and the heat icon does not show on the thermostat. I turn the thermostat off, the furnace continues to blow. Last night to verify, took the thermostat off the wall (but still had the furnace plugged in and... View more questions Search
|