Ask Experts Questions for FREE Help !
Ask
    Brad1231's Avatar
    Brad1231 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 26, 2006, 03:10 PM
    B&S Ignition Wires
    I have a B&S 18HP and I took off the ignition switch since it was really bad looking and thought I would remember where the wires went... however... I DO NOT~ can you give me an idea of what wires go where on the switch... seems it worked and cranked the motor before... and now... well... don't even get a click!! Ugh... Any chance of a color coded selection? I have lots of cool colors... orange, black, red, yellow, green... looks like a christmas tree~~~~~~ Diagram was excellent... just have to figure out where they all go~~~~ unless you have a color chart...

    Thanks again.

    Model 422707

    Thanks,
    Brad~~~~~~~~<><
    thebriggsdude's Avatar
    thebriggsdude Posts: 1,096, Reputation: 53
    Ultra Member
    		  
    #2

    Oct 26, 2006, 05:19 PM
    http://www.tulsaenginewarehouse.com/.../allwiring.pdf
    This may help you...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

3 wires + 2 wires  POOL MOTOR [ 2 Answers ]

I need help connecting a motor for my pool. The motor has 3 wires coming out of it. 1 white, 1 black, 1 black with a white stripe. A continuity test on the 2 blacks says they are wired together somewhere. I have a power cable coming out of the ground. 1 white + 1 black cables inside. ...

Ignition problem [ 3 Answers ]

I have a Miller propane furnace with hot surface ignition. Most of the time it starts and ignites fine, but sometimes the furnace will start but will not light until you open the door and shut it so it resets.I have replaced the Honeywell single try hot suface igniter with a new 3-try igniter. It...

Installing Ceiling Fan Wall Remote with Red & Black Wires? [ 13 Answers ]

I am trying to install a Hampton Bay Wall Remote Control that transmits a signal to a receiver that I will install behind the Ceiling Fan assembly. Problem: Remote instructions state to connect the 2 Black wires from the wall switch to the new Remote switch. The wall switch has a Red and a...

Hampton Bay remote wires do not match fan wires [ 1 Answers ]

Yesterday I installed a new Hunter ceiling fan. I also purchased a Hampton Bay wireless wall switch. Everything went well until I wired up the remote receiver. The receiver has a blue wire for the light that is supposed to connect to the blue wire (light) from the fan. The Hunter fan does not have...

View more questions Search