Ask Experts Questions for FREE Help !
Ask
    beastonator's Avatar
    beastonator Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 26, 2009, 08:44 AM
    Thermostat chirps
    How do I stop Robertshaw thermostat from making load chiping noise?
    KUXJ's Avatar
    KUXJ Posts: 975, Reputation: 97
    Senior Member
    		  
    #2

    Jul 26, 2009, 09:23 AM
    Hi! beastonator, and welcome to AMHD :)

    There's nothing in them that chirps, unless it's my second suggestion.

    Two things to check:

    Do you have a smoke detector overhead in the immediate vicinity of the thermostat?
    Battery powered smoke detectors or hard wired smoke detectors with battery backup
    Have a low battery indicator that chirps.

    Do you have a digital programmable thermostat with a battery backup?
    It may also have a chirping signal to indicate a low battery condition.

    K
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacement of Carrier Heat Pump Thermostat with Honeywell TH6000 series thermostat. [ 4 Answers ]

I have a Carrier Series 50QT Electric heat pump that still uses the original non programmable thermostat. I am trying to replace it with Honeywell TH6000 series programmable thermostat. The wiring on the existing Thermostat as follows: O - White, I am thinking this is the Reversing Valve? Y...

Rewiring from Weathertron Thermostat to Honeywell Thermostat RTH7500 [ 1 Answers ]

I am trying to replace our current Weathertron THermostat with a Honeywell. We have a heat pump with auxiliary heat and central airconditioning. All the wires matched except the Weathertron had a "T" wire and there is no corresponding connectiion that has a "T" on the Honeywell. I have the "B"...

How do I wire my new honeywell thermostat replacing the old tempstar thermostat? [ 1 Answers ]

I am replacing my old thermostat. The old is a TEMPSTAR, the new is a Honeywell model # RTH7500. When I use the directions I end up with one left over wire. We called the Honeywell hotline, the rep. said to wire it like this: red to R, white to O, Yellow to Y, Blue to C, Green to G, Orange...

Thermostat turns on furnace and then thermostat shuts back to HOLD [ 7 Answers ]

I believe that when we re-run the program with the correct date and time, if the temp has to go up, the furnace runs until it gets the appropriate temp, then it turns off and when it does that, the thermostat also turns off going to the HOLD state.:confused:

View more questions Search