Ask Experts Questions for FREE Help !
Ask
    buckcave's Avatar
    buckcave Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 22, 2009, 05:50 PM
    Troy Bilt Electric Clutch pto stops
    Need install tips. I have a project that someone else started and never finished. Need a diagram and advice. Model # 17aa5abp766 Zero Turn. Before he took off the old one and bought the new one the PTO would work for five minutes then stop. Replace the neutal sensors. Still the same problem. Thank you very much.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jul 22, 2009, 07:34 PM

    Hi,
    From past experience I have seen the PTO switch do this. It is not an obvious thing to think it would do, but I saw it on an Ariens ZTR once.
    Saw the manual and parts breakdowns in my search, but no schematic. If it had a relay I would say it was the culprit, but it does not.
    Peace,
    Clarke
    buckcave's Avatar
    buckcave Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jul 23, 2009, 03:13 PM
    Thanks for the info!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy bilt weed eater TB475ss clutch removal [ 3 Answers ]

The centrifugal clutch on my Troy Bilt weed eater TB475ss is stuck. When the engine is running, the shaft will not spin. I can rotate shaft when not connected to clutch. I need removal instructions to separate the clutch from the engine.

Troy-Bilt Lawn Tractor stops moving, engine/blades still on. [ 1 Answers ]

I have a Troy-Bilt Pony, 17.5hp, 8-Speed, 42" Lawn Tractor. At start of the season, started mowing and after approx. 45 minutes, the mower just stopped moving. I disengaged the blades, tried to change speed, direction, and every time I released the clutch/brake pedal, the engine pulley would...

Troy-bilt mower and electric PTO clutch [ 1 Answers ]

I am replacing the lower drive belt on my 23hp Troy-bilt pedal drive garden tractor. The last step in removing the belt is to remove the hex bolt from the center of the electric PTO clutch. When I try to loosen the hex bolt part of the electric clutch and the engine pulley turns at the same time....

View more questions Search