Ask Experts Questions for FREE Help !
Ask
    jond122's Avatar
    jond122 Posts: 4, Reputation: 1
    New Member
     
    #1

    Jul 18, 2009, 09:52 PM
    Wiring thermostat hot water heat
    I have hot water heat. There is a register in my garage with a fan attached to circulate the heat. There are currently 2 thermostats (one for the fan and one to call for heat). I would like to put one thermostat on that can run the fan as well as call for the heat.

    There is a red and a white coming from the fan transformer. There is also a red and white coming from the furnace to call for heat.

    I have a one stage thermostat which calls for a red, yellow, green and white wire. Which terminals on the thermostat (Y - G - W - R) are for the furnace and which is for the fan? Which is hot and ground for each?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Jul 18, 2009, 10:20 PM
    Can your fan be controlled by low voltage 24Volts without using a relay?
    What powers and turns the fan on now?
    Red wire goes to r on tstat ,white wire goes to w on tstat ,this will control your furnace
    jond122's Avatar
    jond122 Posts: 4, Reputation: 1
    New Member
     
    #3

    Jul 18, 2009, 10:45 PM

    The fan is controlled by a low voltage (24 volt) thermostat now. I is a 110v fan. There is a tranformer between the fan and the thermostat.
    ritukuls's Avatar
    ritukuls Posts: 4, Reputation: 1
    New Member
     
    #4

    Jan 9, 2011, 09:13 AM

    Your Furnace wire will go to R and W as polarity doesn't matter
    The fan wire will go to terminals G

    That's All

    ----------

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

.Heat only thermostat wiring. [ 2 Answers ]

I have an existing stat that has two wires coming out of the back. A blue one and a black one. The black is hooked to a black one in the box and the blue is hooked to a red in the box. On my new LUX LV2 stat there is a red line wire on the back and a black load wire on the back. What do I...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Thermostat wiring for heat pump [ 1 Answers ]

I am installing a Honeywell RHT7000 thermostat. My wiring harness has a r, o,y,g,c, and w1. On the old unit e and W1 were jumpered. What do I do when the instructions say to contact a contractor if the new wiring scenario has a w1?


View more questions Search