Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Removing handle from a Moen single-handle shower
[ 5 Answers ]
The shower is dripping and I am trying to get to the stem by removing the handle. I can see a set screw recessed into the bottom of the handle. I have tried an allen wrench but bent it without any success.
Re-install Moen single handle shower handle
[ 12 Answers ]
My Moen shower handle came off. I see there is a set screw at the bottom of it. The handle attaches to a plastic piece; however, you have to pull out the plastic piece from the wall to get the handle to fit over the plastic and to give the set screw something to set into. How do I pull out...
Leaky shower handle/head
[ 1 Answers ]
Hi, OK, I was attempting to fix a leaking cold water shower head. I turned off the water at the road, removed handle & flange. Removed brass thing that was screwed into shower pipe. Took to hardware store, they replaced rubber washer and gave me a tool to remove the seat from the pipe . Well...
Leaky Tub Spout With One-Ball Handle Control
[ 2 Answers ]
I have two tubs with Delta one-ball handle controls. Both of them leak out of the spout. When the showers are running the tub spouts stop leaking. I found some sites that describe how to remove and repair the washers etc on the Handle, but is a spout drip caused by problems in the handle...
Leaky/free turning shower handle
[ 4 Answers ]
I've seen similar posts with fixes (from Speedball, particularly), but I can't find a specific answer for one thing. My shower/tub is a single handle Stanadyne. The handle spins too far in each direction and there's a constant leak from the faucet. From what I've read, I need to replace the... View more questions Search
|