Ask Experts Questions for FREE Help !
Ask
    sharibaby's Avatar
    sharibaby Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 5, 2009, 05:49 PM
    Tub drain
    I am replacing an old tub with a new tub and drain assembly. The assembly will not align with the drain and tub. How do I fix this?
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
    		  
    #2

    Jul 5, 2009, 07:48 PM

    Describe where the alignment is off and maybe I can tell you what needs to be done.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #3

    Jul 6, 2009, 05:42 AM
    How far is it off? If it's less then a inch perhaps you can nudge the trap over. We need more details before we can answer.

    They make a offset tub waste, (see image) that just might solve your problem.
    Good luck, Tom
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #4

    Jul 7, 2009, 05:29 AM
    Bump
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Connecting to 1 1/2" copper drain with pvc kitchen sink drain trap [ 8 Answers ]

I'm trying to rehook up the kitchen sink pvc trap to the old copper drain pipe but the connector doesn't fit tight enough and the water links out. Any ideas how to stop this leak?

Adding washing machine drain to 2" kitchen drain. [ 1 Answers ]

Hello, I have a 2" drain that goes to 1 1/2" for the kitchen sink and connected dishwasher. I am tool proficient and have some plumbing experience. I want to add a washing machine drain breaking out from the 2" hub. The washing machine is 5' away on the same wall. The drain pipe need not be in...

Vent for Washing Machine Drain Attached to Existing Drain Line [ 0 Answers ]

"Current setup for a washing machine has the discharge hose "hooked" into a laundry tub. Tennants would like something more "permanent." The laundry tub has a normal trap followed by a horizontal run of about 2 feet (2" threaded pipe) then "T's" into a vertical drain/vent. The vent line goes...

Outgoing Drain Behind Vanity Cabinet Not Aligned with Sink Drain Tube in New Sinktop [ 1 Answers ]

I'm installing a new vanity cabinet and new marble vanity top, both slightly larger than the originals. The problem we've encountered is that the drainage pipe that will exit sink water from the sink to the house -- the PVC pipe in the house/wall -- is not aligned with the new location of the sink...

View more questions Search