Ask Experts Questions for FREE Help !
Ask
    dren1243's Avatar
    dren1243 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 27, 2009, 07:55 AM
    24hp briggs intek
    The carb seems to be overloading and one side has condensation on the intake.Does not seem to have full power. I have checked to see if it getting fire, changed the plugs, replaced all fuel lines and filters to so far. Any suggestions??
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jun 29, 2009, 05:14 AM

    Hi,
    If you have fuel condensation on one side, I would say you have oicked up a small piece of trash in the inlet needle. The unusual thing about thea carb is that the two throats join and balance just before entering the manifold. It may look as if it is a two barrel carb, but it really is not. The one thing I have found is that today's fuel leaves much to be desired. Cheap fuel filters do not well well and good ones clog because of that.
    If you are getting too much fuel, it is not being burned or having its arrival into the carb's circuitry properly controlled.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Engine switch V twin briggs for Briggs intek ohc [ 2 Answers ]

I would like to exchange a 19 hp V Twin into a Craftsman lt 2000 mower. It was originally equipped with a 22 hp Intek V OHC. I am wondering how different the wiring is going to be. Also is this possible? The 19 HP twin is Model 42A777 Type 1236 01. The Intek is Model 407777 Type 0174 E1 Thank...

Briggs and stratton 14.5 I/C intek [ 1 Answers ]

I need the compression spec for the Briggs 14.5 intek engine. Thank You Kindly Louis D'Amico

Briggs and Stratton Intek won't start [ 9 Answers ]

Hi, I have a new Husquvarna LGT2654 (purchased March 29th) with the Briggs and Stratton Intek V-Twin. It's run fine until now. It's been extremely Hot & Dry in the Memphis, Tn. Area and it's been about 3 weeks since I had to cut the grass... Now it cranks and cranks but won't start. I...

View more questions Search