Programmable Thermostat

bSmith Posts: 1, Reputation: 1

New Member

Oct 17, 2006, 12:56 PM

Programmable Thermostat

Problem with thermostat losing it's power and reseting

labman Posts: 10,580, Reputation: 551

Uber Member

Oct 17, 2006, 06:41 PM

Make sure the red, white, and blue wires are tight. Also, replace the battery.

Add your answer here.

Check out some similar questions!

Honeywell Programmable Thermostat [ 2 Answers ]

Should My Thermostats Panel Operate On The 2 Aa Backup Batteries Or Be Hardwired To Common And Have Batteries As Backup When Power Is Out? Panel Lights Up With Batteries In, Does Not Without Batteries. Don't Know Where Common Wire Originates From. Can I Splice Into One Of The Other Wires, G, Y,...

Noma Programmable thermostat [ 14 Answers ]

I have tried to replace a conventional lever action mercury thermostat with a new digital programmable Noma thermostat. The AC works fine but when I turn on the heat, the AC come on then too and not the heat. I have no heat. This was the wiring for the original thermostat: Orange -> Y Red ->...

Programmable thermostat [ 3 Answers ]

I have a programmable thermostat , but the digital readout says 24.5 degrees all the time. The readout does not change when the temp in the house does. Any suggestions? Markus

Programmable noma thermostat [ 1 Answers ]

I am changing a York thermostat to a Noma programmable. I have rewired transferring w to w, rc to rc, g to g, y to y . There is a wire jumper on the York that goes from rc to 4. There is no corresponding 4 on the Noma. Does anyone have a suggestion as to where the wire jumper should go if I...