Ask Experts Questions for FREE Help !
Ask
    hipster83's Avatar
    hipster83 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 17, 2009, 10:59 PM
    Briggs and straton vanguard 15hp ohv timing trouble
    I have a simplicity riding mower with a briggs and straton 15hp ohv vanguard engine model 280777 type 0612 A1 need to know how far to set the pick up coil from the flywheel
    jsfocke's Avatar
    jsfocke Posts: 310, Reputation: 37
    Full Member
     
    #2

    Jun 19, 2009, 06:16 AM

    For the home mechanic you can use a normal business card between the coil and the flywheel, tighten it down and then rotate the flywheel and remove the card. It should be fine.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

18.5 hp Briggs and Straton [ 4 Answers ]

I have a lawn mower with an 18.5 thatstarts but blows gas up through the carb. It runs but not good.

12 hp briggs and straton [ 1 Answers ]

I have a early 80's craftsman lawn tractor. It's a 12 hp briggs and straton. It will not start with the air cleaner on the motor. If I take the cleaner off it starts, once running I can put the air cleaner back on and it will run like normal.

Briggs & straton 16HP won't run [ 4 Answers ]

Hi, New here so I hope I get it right. I have a Yardmachine ride on mower with a Briggs & stration 16HP vanguard motor (single) 280777. When I try to start it, it run really rough and blow a lot of smoke and oil from the exhaust. I cleaned the carb and checked the soleniod and all seems...

Briggs & Stratton 15hp runs rough at high speed. [ 2 Answers ]

I have a tractor mover with a Briggs & Stratton 15hp, it runs good at lowest speed only, unless I put it at full speed and full choke, it backfire out the muffler and shuts down at any other speed. I ran through the carb, seems clean unless I missed something, the float was stuck and it would...

15HP OHV Briggs - Rocker Arm Question [ 3 Answers ]

Greetings, I have a 15HP OHV Briggs engine on a Craftsman Lawn Tractor that was purchased in 1994. Recently the rocker arm stud backed out on the exhaust valve, I assume from years of vibration. I removed both studs and put loc-tite on them and reinstalled. My concern is that the rocker arms...


View more questions Search