[Robertheard]

I will be installing a dropcieling in my basement , will be dropping it about 3 inches(hopefully this works)My question is when I do, the basement door is to tall. Is it common practice to cut the door lower or to build a swing area for into the configuration of the ceiling for door ,and leave the door at it 80 inch hight.
Thank You
Rob

[ballengerb1]

There is no code to follow for this situation. If you do anything do not cut the door. Boxing a area that allows a door to swing is the only thing that makes any sense.

[creahands]

I agree with ballengerb1. Do not cut door.

Most ceiling grid recommend 4'' minimum to get tile in and out. 3'' to tight area to work tile.

Good luck

Chuck

[Robertheard]

There is no code to follow for this situation. If you do anything do not cut the door. Boxing a area that allows a door to swing is the only thing that makes any sense.

I found out I will only need to cut 2 inches off max, off the top of the door,Do you still recommend to just box it in, either way wouldn't be a problem, Just that I think the ceiling would have a smoother flow all being the same.
Thanks again
Rob

[ballengerb1]

3" or 1/2", do not cut the door. How would you deal with the top of the door frame?

[jon123]

agree with ballenger too, you can use 1x2 fur stripping and rock out for the swing area.. your drop should be minimum 4 " and or you may consider lowest points of pipes etc.