Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
York Diamond 80 heat blower cycles 20 seconds
[ 9 Answers ]
Hi, I have a 1996 York Diamond 80 furnace. Everything starts up OK (thermostat fine, flue fan kicks on fine, then pilot orange glow, then click, then gas burners fire up, then main blower fan starts). This all happens in about a minute or so, but then the main fan only runs for 22 seconds, then it...
York Diamond 80 blowing cold air.
[ 13 Answers ]
Hi All... Hopefully uou can help me out... I have a york diamond 80 gas furnace. It was working fine up until a few days ago.. It began to blow out cold air when the house clearly was not even close to "requested" temp. It turns on, starts the initial motor, the humidifer also kicks...
Inducer Motor on York Diamond 90 Keeps Running
[ 4 Answers ]
I recently had the inducer motor replaced when it burnt out but I am having issues again. The inducer motor keeps running and won't stop until the whole system shuts down. Let me correct myself. I actually am reading about 26 V on the terminals of the pressure switch. The voltage on the...
Where to find an aux spill switch for york diamond 80 furnace
[ 36 Answers ]
I have an error code that says the aux spill swich is open, But I think it is just going bad because it works sometimes and may be getting ready to go bad. Where to find an aux spill switch for york diamond 80 furnace?
York Diamond 90
[ 1 Answers ]
I have a york diamond 90 and I have 4 code show what could it be View more questions Search
|