Ask Experts Questions for FREE Help !
Ask
    chrisnewkirk's Avatar
    chrisnewkirk Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 15, 2009, 09:13 PM
    Turns but no heat
    Replaced parts and dryer no longer squeaks, but now I don't get any heat

    I vaccumed out the vent but still no heat after several minutes of running unit on cottons high heat

    Slight "smell" of dryer heat but no heat
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jun 16, 2009, 02:27 PM
    Gas or electric and what parts did you replace? Brand and model number?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Fan turns off, no heat [ 9 Answers ]

My furnace does not seem to be blowing air. At first I thought it was access panel switch due to a bent panel. However, I held it down while someone else stayed by a register to check airflow and there was very little if none. Also, the gas never lit, but I could smell some. Thoughts?

Heat turns off [ 1 Answers ]

My whirlpool dryer runs good but the heat does not stay on it comes on then goes off

Heater turns on but no flames or heat [ 4 Answers ]

Hello , I have a nordyne ra 80+ upflow/horizontial furnace. Currently my furnace is on but does not give off any heat, rather I see no flames on my furnace. My LED display states there is a fault condition of "Limit circuit open or External load on W" What does that mean. Can anyone shed some light...

Hunter 44155C Wiring - A/C turns on during heat cycle or heat will not shut off [ 0 Answers ]

Trying this again with the correct thermostat specs. Sorry, guys! It's a Hunter 44155C and the wires I have going into it are: White - W/B Red - Rh Green - G Yellow - Y1 Jumper from Rh-Rc

View more questions Search