Ask Experts Questions for FREE Help !
Ask
    ttaylorred1's Avatar
    ttaylorred1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 14, 2009, 07:42 PM
    Thermocouple location
    Where is the thermo couple located on a Whirlpool dryer? Mod# LGR4634EQ3
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jun 14, 2009, 07:52 PM
    Usually there is no t-couple on the newer dryers. They use a ignitor which is located near the burner.
    Fr_Chuck's Avatar
    Fr_Chuck Posts: 81,301, Reputation: 7692
    Expert
    		  
    #3

    Jun 14, 2009, 08:10 PM

    If there was one it would be at the location of the pilot light, but as noted they are not used in the newer dryers.

    So if you have one, follow the gas line in, to where it connects to the burner and look for the piot light location, it would be into the flame ( or where the flame should be if the flame is out)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman thermocouple [ 2 Answers ]

Hi, I have an older Coleman through the wall natural gas heater. The control is on the gas regulator, not mounted on the wall. The problem is "pilot won't stay lit". It uses a thermocouple, 24", the kind you can easily find at Ace hardware. The problem is that the thread at the regulator end is...

Work location is different from employer office location [ 1 Answers ]

I work for NY based company and as an IT consultant. My actual work location is at the client's office which is in NJ for the whole of 2007. I also live in NJ. Will my income be considered as income earned in NJ or NY? My employer has withheld NY taxes though I live in NJ and my work location is...

Thermocouple removal [ 1 Answers ]

How do I remove the thermocouple from a Coleman 7900 seris Presidential furnace? The pilot stays lit only as long as I have the button depressed.

Thermocouple replacement. [ 1 Answers ]

I have a Lennox G12 furnace, about 20 years old, still working well except for the pilot light which has its off moments when it keeps going out. These seem to be periodic in that it will stay on for quite a time then start going out again for a few days, after which it works OK again. I have had...

Burned out thermocouple [ 1 Answers ]

As I had stated in a previous question I have a few minor problems with the furnace in the fourteen years we have it. This is the most annoying one. I have replaced it at least 20 times. A service man installed one that lasted only seven days. I had the gas company install one and it lasted...

View more questions Search