 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
You have some trash that's clogging the hot water inlet port in your faucets cartridge. The solution would be to shut the water off and open up the valve. Pull and clean the inlet ports on the cartridge. While you have the valve open turn the water back on to flush the supplies. You should have a strong hot water stream when you do this. If so then reassemble the valve. Good luck, Tom
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I just came home from the holidays and opened my garage to an exploded hot water tank. I have a shut off valve right above it, so I was able to shut down the water going into the tank without losing water to the rest of the house. The next day was putting in the new tank, and after trying to fill...
Water pressure had been diminishing on a Moen lever kitchen fawcett. Now there isno pressue at all
When turning on the hot water in my kitchen, the pressure drops drastically after ~5 seconds and makes a sputtering sound. Water flow is constant but obviously restricted for some reason. Cold water pressure is fine and hot water pressure is fine in other areas of the house. Any ideas on how to...
A few months ago, out of nowhere, the kitchen sink's hot water pressure became very low. A plummer came over and all he did was totally replace the faucet; nonetheless, the problem still exist so I doubt it's the washers or simply being clogged. I don't exactly trust this plummer; he's saying it...
Recently the hot water pressure has gone down only in our kitchensink. A day or two earlier, ew had to turn our water off for some unrelated plumbing work, and when we turned it back on, the hot water pressure was significantly lower, but only in the kitchen (the bathroom tubs and sinks all have...
View more questions Search
|
