Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Spacing for outdoor garage lights
[ 1 Answers ]
I am from Carlyle, SK Canada. We are in the process of building a 30 x 30 garage. We would like to have 4 recessed pot lights along one side that will shine down. How should these be spaced? Should they be equally spaced along the 30 feet or should they somehow be positioned above the garage...
Adding lights to existing exterior light circuit
[ 1 Answers ]
I have a light fixture that is flush mounted in the ceiling of an exterior porch, I would like to add two more twin bulb floodlights switched by the existing switch if this is okay to do. If so can I run wiring from the current fixture through conduit along the undersides of the eaves, and if so...
Garage door opener lights won't come on?
[ 3 Answers ]
I have an alliance genie garage door opener ( Model # 600), which holds two light bulbs, when operating the garage door up and down niether light bulb will come on. I removed the exterior housing from the unit and checked all wiring connections everything seems to be OK? What do I look for next?
Exterior drainage - paths slope towards garage
[ 1 Answers ]
After a few rainfalls, I realised that water seeps into my aluminium clad garage from concrete paths on 3 sides and from a slight bank on one side. I've put drain-coil into the bank and dug a trench to below ground level on that side but the trench still tends to fill up. This side gets run-off...
Hampton Bay Exterior Motion Detect Lights...
[ 1 Answers ]
This will be a dumb question, but our contractor put up two of the Hampton Bay Motion Detecting lights on our detached garage. The problem is that they pitched the boxes, and the directions before we even had a chance to figure them out. Now, only the test works, which stays on for 10 seconds. ... View more questions Search
|