Ask Experts Questions for FREE Help !
Ask
    white boy's Avatar
    white boy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 9, 2009, 10:59 AM
    Honda 13hp will not start
    My honda 13hp riding lawnmower will not start I bought a new sparkplug but that didnthelp I don't know what to do?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jun 9, 2009, 11:29 AM

    Pull the plug wire and remove the plug, reintsall the wire and let the plug tough the engine block to be grounded. Turn your key and tell us if you see a good blue spark on the tip of the plug. If you have agood spark then we should check the fuel, start by draining what you have and remove the bowl. Refill with freshly bought fuel, did it help?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

13hp mtd not starting [ 2 Answers ]

My 13hp yard machine by mtd not starting.I replace the coil after I had no spark,it only ran for about 20 minutes.Now it won't start and I have no spark.Iwonder if it is the coil again?

13HP MTD Yard Machines Rider Won't Start [ 9 Answers ]

I would like your advice as to the next step I should take to get this mower going. It's a MTD 600 series rider from 2001 with a 13 HP Briggs (28T700). This machine ran a month ago but now it won't. The starter will engage the engine and it will "run" while the starter is engaged, but the engine...

91 honda crx no start or rough start, puzzled HELP! [ 5 Answers ]

Ok, I'm running a SOHC ZC motor. I have good compressions across all pistons at 135psi and holding a piece. I have checked the timing and it is correct. I have checked the fuel pressure and it is OK. I haven't been able to figure out how to lean the fuel out though, but anyway, it starts up and...

Flywheel help on briggs/stratton 13hp snapper [ 11 Answers ]

My threads are knackered on the end of my flywheel for the pull start is there any way to bodge it up even if it means welding a bolt on the top just to hold the flywheel on:confused:

13hp briggs and stratton [ 3 Answers ]

Help needed please I have a hayter ride on mower with a 13 briggs stratton engine .it will run OK without the air filter and breather pipe connected but as soon as I refit the air filter ,plug rubber breather pipe in place and then it won't start .if I put my thumb in the breather it won't run .I...

View more questions Search