[brenda810]

When I flssh the toilet the water comes up and slowly drain

[massplumber2008]

Hi Brenda...

Try using the plunger and see if that can unclog this toilet.

If that fails, then go to a home supply store and purchase a CLOSET AUGER... see image. This tool inserts into the toilet bowl and you turn the snake and push it into the bowl and through the trapway of the toilet.

This should unclog the toilet unless there is an object that fell in and even then the auger can be used to pull that "something" out if you use the tool correctly!

Let me know if you have questions...

MARK

[speedball1]

I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps and thank you for rating my reply.. Tom