Ask Experts Questions for FREE Help !
Ask
    golfinfool2003's Avatar
    golfinfool2003 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jun 3, 2009, 08:30 AM
    Gas will not stop flowing into the carburetor
    I replaced all of the fuel lines and gas filter, but gas will not stop flowing into carburetor, I replaced the fuel pump thinking it might be the problem but it still will not stop, I checked the choke to make sure it opens and closes like it should and that seems to fine, what should I look for now? Any help would be greatly appreciated.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Jun 3, 2009, 10:37 AM

    If fuel keeps pouring into the carb its because the float is not closing the needle valve. Drop the bowl and manually raise and lower the float to see if it moves freely and shuts off the gas. Some old floats could actually leak and fill with fuel so they did not float well enough to close the needle. Let me know what you find and we'll go from there. Bob
    golfinfool2003's Avatar
    golfinfool2003 Posts: 2, Reputation: 1
    New Member
     
    #3

    Jun 6, 2009, 02:01 PM
    Quote Originally Posted by ballengerb1 View Post
    If fuel keeps pouring into the carb its because the float is not closing the needle valve. Drop the bowl and manually raise and lower the float to see if it moves freely and shuts off the gas. Some old floats could actually leak and fill with fuel so they did not float well enough to close the needle. let me know what you find and we'll go from there. Bob
    I took the bowl off and did what you said, the inside of the bowl had some dirt and rust in there so I cleaned it out with some WD-40, I think the float may have just been stuck, put it all back together and she started up on the first crank and she runs great, so thank you for your help it is appreciated

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carburetor bogs out [ 4 Answers ]

I have a 72 gmc pickup truck with a 350eng and a edelbrock 1406 4brl carb.the problem I am having is while driving the fuel is getting to the carburetor but after about 20min it starts to cut off then it just cuts off,at first I thought there was air coming into the line from the gas tank to the...

Carburetor not getting fuel. [ 1 Answers ]

Can and how do you bypass anti-after fire solenoid?

Gm 2 jet carburetor installation [ 1 Answers ]

I just got a new carburetor for my 62 chevy bel air... its a newer model of the gm 2 jet carburetor... my problem is the new one has more connections and is somewhat different than the original. My knowledge of cars is very limited... this is my first hot rod... I guess my questions is how do I...

Rebuilding carburetor. [ 4 Answers ]

I am getting ready to rebuild my carburetor on an 86 yamaha virago 700 and was looking for some pointers before I start... I've never done this before...

Overflow pipe does not stop flowing [ 1 Answers ]

Hello I have a problem with my overflow pipe on my geyser, it continueosly run. As far as I knew it is only suppose to run once the pressure build up is to high in the geyser, it then opens to release any excess steam and pressure. How can I get it to stop dripping because it is causing a swamp...


View more questions Search