Ask Experts Questions for FREE Help !
Ask
    geoffjenkins05's Avatar
    geoffjenkins05 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 2, 2009, 05:26 PM
    How close can I build a wall to a furnace?
    We are build a room in the basement and the seam of the house runs about 7 inches next to the furnace. It is only one side and does not block the access panel.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jun 2, 2009, 05:49 PM

    Can you explain this in different terms "and the seam of the house "
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
    		  
    #3

    Jun 2, 2009, 07:35 PM

    You need to check the specs for that furnace and see what the clearance margins are from surface that will burn.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #4

    Jun 2, 2009, 07:44 PM

    Still waiting to hear an answer to my question but more than specs, check you city building code for space required and types of wall material. Ome codes call for fire rated drywall on walls and ceiling, kind of crazy if you ask me but that's codes for you.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Help! Toilet Too Close To Wall! [ 3 Answers ]

The toilet in our upstairs bathroom has been installed too cose to the wall. The lid to the bowl won't even go on completely because there is not any clearance between the back of the tank and the wall. I measured from the closet bolts (?) to the wall and it measured 11 1/2". What are my options...

Sandy build up on hot tub wall [ 4 Answers ]

Hi, I have a sandy feeling build up on my hot tub walls and all surfaces covered by water. How can I get rid of it? Will it harm my pipes or any other part of the hot tub? Thank you

Dialing in a footing to to build a wall to close in an existing attached garage [ 1 Answers ]

I'm in nc an inspector called me and told me to dial in a footing where I'm going to build a wall. I might drill about 8 two foot long rods into the existing 18' long footing then lay two #5 continuous rods tied to the rebars. Put some visqueen down. Here in oxford nc carolina they want the footing...

My toilet is too close to the wall [ 6 Answers ]

The people who built my house put the drain hole for my toilet too close to the wall. It is at a 11 1/2" So it is so close that it molds behind it and I cannot clean behind it.. Should I buy a new toilet to put some space between the wall and toilet or just leave it the way it is? I suppose I...

Toilet to close to wall [ 7 Answers ]

I'm in the process of the replacing the toilet in a basement bathroom. The new toilet will not fit because the center of the flange is only 9 1/2 inches from the wall, rather than twelve. I broke all the concrete around the pipe. It is cast iron. What is the best way to move the flange 2 1/2...

View more questions Search