Ask Experts Questions for FREE Help !
Ask
    allench1's Avatar
    allench1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 31, 2009, 04:40 PM
    Kenmore Washer 80 Series NOT SPINING!
    I have a Kenmore washer 80 series, First it would not agitate so I changed the
    Coupler which connect to the motor and started washing. It worked fine until
    It came to the spin cycle , it started to spin pretty slowly and I could hear a tapping
    Or ticking type of noise. I checked and it was coming either from the motor or the transmission where the coupler fits in between the motor and trans.
    PLEASE HELP WITH THIS!! :confused::confused::confused:
    W4CSL's Avatar
    W4CSL Posts: 8, Reputation: 0
    New Member
    		  
    #2

    May 31, 2009, 06:10 PM
    There are a set of points that take open and close as the timer on the front of the machine turns the clicking sound is probably the set of points the operates the motors spin cycle trying to engage I suggest that you remove the back of the washer and find what should look like a small box turn your washer to spin as listen for the one that needs to be replaced they maybe located behind the front control panel
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What is the capacity of my Kenmore 80 Series Washer & 90 Series Dryer? [ 1 Answers ]

We are trying to figure out what the capacity is of our Kenmore Washer and Dryer that we purchased over 10 years ago in Canada. I can't find it anywhere on the machine or manual. The Model # of the Kenmore 80 Series Super Capacity Plus Washer is 110.4784292, Serial #CH0802766. The model # of the...

Kenmore 80 series washer [ 5 Answers ]

It stopped agitating and spinning? I am broke so I will try to fix myself so what should I do first to troubleshoot it?

Kenmore series 70 washer [ 1 Answers ]

I have a Kenmore series 70 washer that will not agitate. I have searched and everything says to remove to bolt in the agitator and then remove the agitator. My problem is that the bolt will not loosen or tighten. If I put my socket on the bolt and then turn the machine on to agitate, it moves...

View more questions Search