Ask Experts Questions for FREE Help !
Ask
    Grinderman's Avatar
    Grinderman Posts: 3, Reputation: 1
    New Member
     
    #1

    May 29, 2009, 06:26 AM
    14.5 ohv briggs engine ?
    Hello I am just wondering if you can replace the soloniod on the carb with a manual needle valve like in the older briggs engines.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    May 29, 2009, 10:12 AM

    Hi,
    No you cannot use an adjustable needle because of the EPA. There is a simple plug that it can be replaced with. Warning: this is an overhead valve engine and that solenoid has a purpose! If you do replace it, you MUST throttle the engine down for a few seconds before shutoff.
    691657 is probably the part number, but you did not provide the engine numbers.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Engine switch V twin briggs for Briggs intek ohc [ 2 Answers ]

I would like to exchange a 19 hp V Twin into a Craftsman lt 2000 mower. It was originally equipped with a 22 hp Intek V OHC. I am wondering how different the wiring is going to be. Also is this possible? The 19 HP twin is Model 42A777 Type 1236 01. The Intek is Model 407777 Type 0174 E1 Thank...

12.5hp I/C Briggs&Stratton engine [ 3 Answers ]

I went to start my riding mower for the first time this year and when it started is smoked real bad. I turned it off and checked the oil, it was over filled. I went to drain the oil and discovered it had gas in the oil. It ran fine last year, but I didn't drain the gas out at the end of the season....

Briggs engine [ 1 Answers ]

I have a briggs 23hp on my mower. Many times when I try to start,it tries but doesn't. If I turn engine bach 1/4 turn by had at fan cover it starts fine. The battery is new and fully charged. What could cause this? Thanks

12 HP Briggs engine [ 2 Answers ]

I have a 12 HP briggs and stratton engine that will start when choked and then only run while between choke and full throttle position. I have cleaned carb. And checked fuel supply. Any Suggestions?

Briggs 12 HP engine drags [ 2 Answers ]

I have a B/S 12 hp 28000 series engine. Rebuilt the engine and now upon trying to start, the engine drags and won't start even on the charger. It doesn't appear to be spinning fast enough so I bench tested the starter. When it spins it sounds real rough (whining sound) Connections are tight,...


View more questions Search