Ask Experts Questions for FREE Help !
Ask
    jonwilliam's Avatar
    jonwilliam Posts: 31, Reputation: 1
    Junior Member
     
    #1

    May 23, 2009, 06:43 PM
    Intertherm wall furnace
    Hi guys

    The Intertherm wall furnace No heat at all. I cannot get 24 vac from the fast thermostat inside the unit and the unit is dead nothing happening at all . I would think the culprit is the fast thermostat . I checked out the relay , the relay cannot get 24vac on the coil to get energized . The other side of the relay I get 120 vac on the spade terminals . Found out that the relay was OK however cannot be energized at all.
    You comments will be appreciated
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    May 23, 2009, 08:41 PM
    Have you checked for n24volts of power coming out of the transformer?
    jonwilliam's Avatar
    jonwilliam Posts: 31, Reputation: 1
    Junior Member
     
    #3

    May 23, 2009, 10:13 PM
    Quote Originally Posted by wmproop View Post
    have you checked for n24volts of power coming out of the transformer?
    Yes I did there is 24 vac out of the transformer . Tks

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm elc. Furnace [ 1 Answers ]

I Have an intertherm elc. Furnace and sometimes the fan will continue to run after the heating cycle and sometimes it will kick off like it should. The fan will run for hours until I hit the front of the furnace door then it will kick off immediately. Any idea what the problem is?

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Intertherm wall heater [ 1 Answers ]

I have a mobile home with an Intertherm wall heater. Where do you tell the heater when to come on? It comes on when I don't want it to

Intertherm furnace [ 2 Answers ]

I have just in the last month had an Intertherm furnace installed, and since installation they have had to come in twice because they claim the starter button is not firing. They replaced it and now it is on the fritz again. It starts for about 8 seconds and cuts out. There is fuel in the tank....


View more questions Search