Ask Experts Questions for FREE Help !
Ask
    buddy1987's Avatar
    buddy1987 Posts: 13, Reputation: 0
    New Member
    		  
    #1

    May 22, 2009, 06:03 PM
    1995 chevy blazer won't work
    My 1995 chevy s10 blazer started to surge at low rpms and would eventually die, I have replaced the fuel pump, fuel filter, throttle positioning sensor, EGR valve,idle air sensor, bosch spark plugs and wires, the coil, checked fire and it fired on all cylinders, the fuel pressure stays at a steady 60 psi at the checkpoint... have ran several cleaners through the fuel to reduce carbon buildup, and there is no fuel or gasket leaks.. it won't even start... it has no codes on the computer either... does anyone know what's wrong with it?



    Thanks
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    May 23, 2009, 12:59 AM

    Replace the Ignition Contol Module:

    AutoZone.com | | Control Module - Ignition | CONTROL MODULE

    In the future, I would only use ACDelco spark plugs--many people have problems with Bosch.
    buddy1987's Avatar
    buddy1987 Posts: 13, Reputation: 0
    New Member
    		  
    #3

    May 23, 2009, 02:44 PM
    Where is that located? I looked at a new one but can't seem to find it on my blazer...
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    May 23, 2009, 02:51 PM

    Should be located next to the coil pack.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1992 chevy s10 blazer [ 2 Answers ]

Where is the fuel pressure regulator on a 1992 s10 blazer, mine is running rough and the smell of fuel is very extreme, si suspect the diaphragm has gone bad and raw gas is leaking into the manifold but don't know where to find it.

My 1995 chevy blazer won't start [ 2 Answers ]

I have an old one, a 1995 chevy blazer. It stopped one day and I have been able to get it start since. We changed fuel fliter, spider injector pump, and fuel pump in the tank. I checked to see if fuel relays are working and they are. The pump in the tank is working, while changing the filter we...

1995 blazer you joints. [ 2 Answers ]

I have a 1995 blazer with bad ujoints.I was going to change them but there are no retaining rings on ends,just metal caps.I can't figure out for the life of me how to get them off.And when or if I do get them off,are there grooves in them for the retaining rings I got with the new ones? Thanks for...

1987 chevy blazer S-10 [ 1 Answers ]

I'm trying to figure out how to remove the steering wheel so I can out in a new ignition switch.

Registration for '99 Chevy Blazer? [ 1 Answers ]

Anyone have an estimate of how much it would cost to register my '99 Blazer? Thank you! :D

View more questions Search