Briggs and Stratton Vanguard 16 HP Vertical engine

pennyjim Posts: 1, Reputation: 1

New Member

May 7, 2009, 11:35 AM

Briggs and Stratton Vanguard 16 HP Vertical engine

Briggs and Stratton Vanguard 16 HP Vertical engine what is the push rod gap for intake and exust

61hawk Posts: 4, Reputation: 1

New Member

May 7, 2009, 12:09 PM

.004-.006... both are the same

Add your answer here.

Check out some similar questions!

Briggs & Stratton 18 HP Vanguard [ 5 Answers ]

I am trying to fix a Toro 3100 Triplex mower used on a golf course. The machine has about 2500 hours on it. It is powered by a I am trying to fix a Toro 3100 Triplex mower used on a golf course. The machine has about 2500 hours on it. It is powered by a Briggs & Stratton 18 HP Vanguard V-Twin ...

Briggs and stratton vanguard 16 hp twin engine with no spark [ 10 Answers ]

I have a new Briggs and Stratton Vanguard 16hp twin installed in an ATV. Unfortunately on a shakedown run the exhaust pipe loosened and fell on the wireing harness from the ignition key and the engine immediately stopped as the pipe melted through the wire insulation, I assume shorting something...

Briggs and Stratton Vanguard 18 hp engine [ 2 Answers ]

Can someone tell me how to drain the oil on a Vanguard Briggs and Stratton 18 hp engine? I have located the drain plug but there is some kind of plastic fitting over it with a flip-off nozzle on the end as if this is where the oil drains. It does not appear that the plastic fitting comes off. So,...

Briggs and Stratton Vanguard OHV Engine [ 1 Answers ]

I have a new Briggs and Stratton 8000 watt generator powered by a Vanguard 15 hp overhead valve engine.Since it came from the factory it has a popping sound from the muffler as it runs. It seems as though there is a misfire. The spark plug has been changed and the spark is in spec. Service dealers...

Briggs & Stratton 16 hp Vanguard [ 2 Answers ]

Hello all, I have a this 16 HP Vanguard motor that came on a Dosko stump grinder. My problem is that the fuel will weep into the block and fill my cylinders. It also drips out of some sort of metal intake line that has nothing attached to it. This intake does suck air as it will kill the engine if...