Russell cox- she gave you really good advise :: in case you need to go into more checking it out heer is what to do;;; you will need to have a {volt ohm meter} in order to test the items you will need to :: } #1under the tub on the motor there are two soleinods < one that controls the { agitate and one that controls the spin cycles:: #2- to test these out ; unplug thr power cord from the wall receptical , set the volt-ohm meter to the rx100 scale :: leave the power off durning these tests rx100 scale ;;; pull the washer out from the wall and remove panel to get to where you need to :: remove the wires from one of the soleinods and clip the meter probes to the wire terminals: if the meter reads {250 to 1000 ohms] the solienod is good <if it reads higher then it is defective -replace { note } if one solienoid is bad : it says to replace both at the same time : if it's good replace wires and test the other one <the same way : if this is not the problem <then it could be either the lid switch or it could be the {timer }switch:: { note } on some washers the soleniods are internal on the motor and you will have to take the motor off and take it to a shop to be repaired } ::: #2- to test the lid switch: to get to the switch you will hsave to raise the top up : you will be able to see the switch <it will be either a button or a lever:: #2a-set the volt ohm meter to the rx! Scale: < power off the switch coulld be broken or out of adjustment or defective:: use your finger to reach under the splash cover to see if the switch is brokrn or not:: #3- to find out if sweitch is defectivre or not:: disconnect the wires to the switch <cliop the meter probes to the wire terminals <if the meter reads {zero ohms } the switch is good -if it reads high<<then it is defective {replace } if it is good then to check the switch for adjustment :: #4a-to adjust the switch- with a nut driver loosen the mounting screws and reach under the cover with your finger and just move switch a very little at a time:: you will hav to retighten the screws after every time you reset the switch <because you will have to recheck it after every time you reset <untill you have adjusted it right ::: if what you have done so far checks out good then you will have to go to the timer switch:: good luck and let us all know how you come out :: if i have helped you out <please rate my answer using the orange box below : have a great day and god bless ::f.b.e. sorry about the book
