Ask Experts Questions for FREE Help !
Ask
    rstev49958's Avatar
    rstev49958 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 30, 2009, 07:39 PM
    Need to locate an Air cleaner for an older Briggs and Stratton
    Hello,

    I have been searching for an air filter cartridge/foam overlay cleaner to fit an old Briggs and Stratton, used to power a Craftsman tiller. The model is 247298610/a227c. It has a 5 HP B&S. I have searched the Sears Direct website and found the engine, but no air cleaner parts. I also need the carb diaphrahm. Does anyone know where these parts might be available.

    Thanks
    Fr_Chuck's Avatar
    Fr_Chuck Posts: 81,301, Reputation: 7692
    Expert
    		  
    #2

    Apr 30, 2009, 07:47 PM

    Have you called one of a 1000 briggs service centers in every state in the US.

    Call a briggs repair shop.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Older Craftsman Tiller w/5hp Briggs and Stratton [ 11 Answers ]

I recently acquired an old tiller that I have gotten to run. It will only run on full choke. It will only till for about a minute or so before going dead. It will idle for a long period, but it's kind of a rough idle. Do I need to adjust the carberator? I have already changed out the gas and...

Carb settings on older briggs and stratton engine [ 3 Answers ]

I have a model 190432-2535 briggs and stratton 8 hp engine and I need help with resetting all three carb screws. Any ideas what they should be?

Briggs & stratton v-twin oil soaked air cleaner [ 1 Answers ]

I have a wood's riding mower with a Briggs 18 HP v-twin engine. After mowing 2-3 times the air cleaner is soaked with oil and the engine loses power. Rings have been replaced and all o-rings and gaskets. Has there been problems with air cleaners not allowing enough air into the engine. The...

How to adjust governor on older 8HP Briggs and Stratton mower motor [ 1 Answers ]

I had to dismantle two engines to make one. Have forgotten how to adjust governor. I have fully closed buttefly in carby, and turned governor actuating lever fully anti-clockwise before re-tightening clamp on governor arm. Is this right or wrong?

View more questions Search