Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cutting through cast iron How is it possible to cut through a cast iron soil pipe
[ 6 Answers ]
Cutting through cast iron How is it possible to cut through a cast iron soil pipe
Lead to cast iron junction
[ 1 Answers ]
How to repair junction where lead junctions with cast iron and pinholes has developed
Toilet Install w/ Lead Sleave & Cast Iron Pipe
[ 4 Answers ]
I am installing a new toilet. The original construction had a sub floor, which has been removed by the previous owner. Rather than properly seating the flange on the concrete floor, he put tile grout under it to compensate for the wood sub floor that was removed. The old toilet was sitting about...
Cast Iron Lead sealed plumbing
[ 1 Answers ]
I have an older home that has a vented stand cast iron plumbing (4-6" diameter), and the joints are sealed with lead. I need to rotate one tee joint (runnuig vertically). Do I have to heat the lead to a molten state to allow rotation? I have never worked with lead sealed pipe and while this...
Lead Pipe/cast iron
[ 4 Answers ]
Hi! I just removed drywall to fix a drain from a bathroom sink. I found 1.5" soft lead pipe from the p-trap to a 3" hub on the cast iron stack. Can I use some kind of coupler from the lead pipe to new plastic or do I need to replace the entire length of pipe? If I need to replace, what's a good... View more questions Search
|