Ask Experts Questions for FREE Help !
Ask
    G-Man123's Avatar
    G-Man123 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 25, 2009, 04:26 PM
    Repair of furnace blower for Bryant 350MAV
    I was told by a service repair firm that the blower motor and wheel needs replacing for a Bryant Model 350MAV condensing gas furnace (10 years old). There is quite a bit of noise when it runs and the unit vibrates at bit at the blower housing. His cost was nearly $1000. I think I can do it myself. Are there instructions available for replacing the blower and where would I buy the blower.

    Thx,

    G-Man123
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Apr 25, 2009, 08:00 PM
    Sounds to me like you only need to replace the blower wheel for now ,if the motor was bad and needed replacing,, it wouldn`t be running and vibrating

    Take the model number with you and find a parts house for Bryant furnaces that will sell the part to you

    If you are machanical enough to think you can do it yourself,, you shouldn`t need written instructions
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #3

    Apr 25, 2009, 08:07 PM
    If your blower wheel spun on the motor shaft when it went bad you will need a new motor. The new blower wheel will not be able to lock down tight on the blower motor shaft.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 90 350mav code 34/14 [ 5 Answers ]

I have a Bryant 350mav that is giving a code 34 followed by a code 14 . I checked the intake and exhuast pipes and they are clear. What next? It is blowing cold air, cycles the 3 times and then locks again.

Bryant furnace repair [ 1 Answers ]

Why won't the blower on my older gas furnace work

Bryant 350MAV inducer housing leaking [ 6 Answers ]

I have a 13 year old Bryant 350MAV gas furnace. The 2 halfs of the inducer housing are leaking water. Can these 2 half be pulled apart and resealed? If so what special type of silicone needs to be used if any?

Bryant 350MAV only runs in the mornings [ 6 Answers ]

Hi Everyone, I have a strange intermittent problem with my Bryant 350MAV furnace that has arisen in the last couple of months, since the weather started to cool here in Los Angeles. I usually turn off the thermostat at night when I go to bed, then manually turn on the heat in the morning when...

Bryant Model 350MAV Furnace [ 3 Answers ]

Hi, I recently had a furnace repairman in who told me our inducer on our Bryant Model 350MAV furnace needed to be replaced. He said the total cost would be $1075.00, including $890.00 for the inducer. This seemed high to me. Can anyone give me an idea of what this repair should have cost,...

View more questions Search