Ask Experts Questions for FREE Help !
Ask
    coolbreez55's Avatar
    coolbreez55 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 22, 2009, 10:53 AM
    208-220 single phase
    Can I run a 220 single phase dc motor controller on 208 single phase ?
    Any help would be great.thank you
    Bob
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Apr 22, 2009, 11:39 AM
    Please re-read your question.

    You mention DC.

    Is this true?

    If this was a typo and you meant AC, then why only asking about the motor controller, and not the motor?

    A controller does not utilized voltage, it is only a switch, other than the coil, if it is a magnetic controller, which must match the voltage the control circuit is providing.

    I can go all over all the possibilities. May be better to re-read the question, correct any typos, and provide detail on the controller.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Can three single phase loads be driven individually by single three phase supply [ 2 Answers ]

Hi... I am new this community... You are doing great job of knowledge transfer... My question: Can three single phase loads be driven individually by single three phase supply? Please clear my doubt... :confused:

How do you usually connect three single phase loads to a three phase generator? [ 2 Answers ]

How do you usually connect three single phase loads to a three phase electric generator?:)

Detail explanation of eletrical between 3 phase and single phase [ 1 Answers ]

Hi, I do confuse between 3 phase and single phase,may I get some detail and comparison for each of them?

208 volt3 phase why to single phase 120 volt [ 4 Answers ]

Supply is from 75 kva transformer, 3 phase delta /y three wire feeding a 30 amp breaker. 100 feet down stream is a junction box that I want to tap and produce a 120 v single phase ( 20 amp CB) supply. The junction box feeds a 6 amp motor

Changing out 3-phase motor for single Phase [ 1 Answers ]

Besides matching the mounts & drives, are there wiring/switching issues changing out a 220-3phase for 220-S-Phase. I am interested in switching motors in a commercial diswasher.

View more questions Search