Ask Experts Questions for FREE Help !
Ask
    wilnaz's Avatar
    wilnaz Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 16, 2009, 08:28 PM
    Goodman Furnace
    My furnace is pulsating, gas valve is clicking on and off rappidaly, I shut it off for a short time then it will work for a few hours then start acting up again installed new air pressure switch no change,do you think I should replace the flame sensor.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Apr 18, 2009, 07:32 AM
    Intermittent operation/pulsing like this could be caused by the thermostat. Disconnect the red thermostat wire in the furnace low voltage area and see if it stops. If it does stop then you need to check the ow voltage wiring and the thermostat. If it continues then it would be best to call a professional since the problem can be serious.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Goodman furnace [ 2 Answers ]

Goodman furnace circuit board has heat and cool. No wires to heat but wires to cool. Is there sopposed be a wire from fan to heat? Just installed new fan and a/c works, just tried to turn on the heat and it went on for a while than shut off. What's up with that? Please help...

Goodman Gas Furnace [ 3 Answers ]

I have a Goodman Gas Furnace, the hot surface ignite will not come on nor the flame sensor. I have tried everything and I am fresh out of ideas. Could you please help me on this. Thanks

Goodman Furnace [ 3 Answers ]

I have a six year old Goodman Furnace that will not kick on or even begin the start up cycle. Last year I replaced the ignitor and checked it out today and looks fine. Any obvious place I should start to determine the issue? Thanks Jim

Goodman gas furnace [ 1 Answers ]

I have a newly installed Goodman gas furnace.It's 93%efficiency natural gas ,forced air,model #capf3o30b6ah Does not blow out very warm air , is this normal.

View more questions Search