Ask Experts Questions for FREE Help !
Ask
    jtv3560's Avatar
    jtv3560 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 16, 2009, 01:21 PM
    Murray riding mower
    I have an older murray rider.It's a 30",12hp,rear engine.Can anyone tell me where to find the model#.I looked under the seat and on the frame and haven't had any luck.Thanks Joe.
    mikevr's Avatar
    mikevr Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Apr 16, 2009, 04:44 PM

    I have a Murray riding mover-40 inch cut-13.5 hp- when starting nothing happens- I changed the solenoid still no good- jumpering across solenoid terminals starter moves- can I jumper across the solenoid terminal to start the mover and cut the grass- is it a good idea- if not any suggestions-
    Thanks
    mikevr
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Murray riding mower [ 4 Answers ]

I have a Murray Model 42910x92a riding mower. I started it the other day and it ran for about 2 minutes then died. I tried to start it again, but the starter would not turn over; there was no "click" of the solenoid. I checked the battery, has plenty of juice. I bridged the solenoid and the...

Old Murray Riding Mower [ 1 Answers ]

I have just come to own a Murray 11 HP riding mower with a 36 in. mowing deck. It has a briggs and stratton engine. I am trying to fine the model number of the mower so I can look for a service manual. I find nothing under the seat, or under the engine cowel. Any ideas or suggestions on where...

Mower Replacement Belt, Old Murray Riding Mower [ 2 Answers ]

I have a model 38618X92E. I am looking for a manual or parts catalogue for this model so I can find the proper replacement belt. Thanks.

Murray riding mower [ 2 Answers ]

I have a murry riding mower and the drive belt broke I need a diagram of the complete drive belt system showing how the belt goes around all pullies it is a 14.5 motor with a 42 incn deck if you have one please send it to me at this address [email protected]

Murray Riding Mower [ 1 Answers ]

I have a murray riding mower that I purchased in August of 1991. Apparently I need a new transaxle because it will not go in gear at all. The part # in the book is Dana model 4450-1 which I have been unable to locate, the only reference I have come across for the part says that it has been...

View more questions Search