Ask Experts Questions for FREE Help !
Ask
    Delboy1's Avatar
    Delboy1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 10, 2009, 02:46 AM
    Service Connector Honda Civic 92
    Hello

    Where is the service connector located on a honda civic 92 and what does it look like
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Apr 10, 2009, 06:00 AM

    Service Check Connector

    When the Check Engine Light (CEL) is on, it will be necessary to locate the 2-pin Service Check Connector (SCC) on OBD-I (pre-1996) Hondas. It is normally located under the dash, approximately 1 inch (2.5 cm) from the right kick panel. Take a small screwdriver and carefully pry it from the rubber mount. The other 3-pin connector in the rubber mount is the Data Link Connector (DLC), which should be left alone. Jump the SCC with a paper clip, turn the ignition switch to ON (Position II), and count the number of times, if any, the CEL flashes. Reference a Diagnostic Trouble Code (DTC) chart to identify the code being displayed. The SCC is also jumped, when an induction timing light is used to check engine timing.

    After troubleshooting, turn the ignition switch OFF, remove the jumper wire, and reset the ECM, by removing the BACK UP (7.5 A) fuse from the under-hood fuse box for 10 seconds. Disconnecting the BACK UP fuse cancels preset radio stations and the clock setting; therefore, they will need to be reset.
    oregonslight1's Avatar
    oregonslight1 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Feb 27, 2011, 03:41 PM
    Just did this and it did not work.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Location of service check connector [ 2 Answers ]

I need to adjust the timing on a 91 Honda Civic. I ned to jump the service check connector with a paper clip. Where is the service check connecter located?

Jumping the 2-P Service Check Connector with a paper clip, [ 1 Answers ]

I am trying to troubleshoot my ignition system for a 1990 honda civic using TXGREASEMONKEY notes. #3 says jump the 2-P Service Check Connector with a paper clip. What does this mean? Explain how I do this please.

View more questions Search