Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Cut stainless steel
 [ 5 Answers ]
 How do I cut holes in a stainless steel sink? 
Replacing bedroom hollow doors with 6 panel pine doors.
 [ 4 Answers ]
 I am replacing my bedroom hollow doors with 6 panel pine doors. My problem is that the 6 panel pine doors are not fitting properly. When I hung one door with the same size hinges I was able to put the screws in the same holes as the old ones but the door will not close. The new door is about... 
Sharpening Steel
 [ 9 Answers ]
 I recently got a few very nice Global knives for my birthday. LOVE them. As a budding home chef I never realized what a difference good knives made. The pamphlet that came with them says that I should use their special sharpening steel. It is both hard to find and expensive. Does anyone... 
Steel Behind my brick?
 [ 2 Answers ]
 I'm trying to run Sat cable and speaker wires into my house. Drill through brick no problem, then I hit something like steel, it's not magnetic, I'm burning up all my drill bit's.I thought may a stud or something, I tried another hole approx 6" over and same thing.Oh yeah I'm drilling about 5... 
Steel Plate
 [ 1 Answers ]
 
I am drawing for a manufacturer to bend steel plate into a U shape. The steel is galvanised and 1.5mm thick. How do I show the Radius of the bend? What is the maximum radius I can bend with 1.5mm steel? View more questions Search 
  |