Ask Experts Questions for FREE Help !
Ask
    csw12493's Avatar
    csw12493 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 5, 2009, 08:47 PM
    Who made this diverter 3-handle garden tub/shower
    House was built in 1986. Need to replace the center diverter but Delta claims my current diverter was not made by them. I was able to replace the hot and cold diverters with Delta parts but I don't know who made the center diverter. I have a roman or garden tub. This is larger than a standard tub. Attached picture, closest diverter is my old diverter length 4 3/4" second diverter is the one Delta sent me but does not fit. Please help!
    Attached Images
     
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
    		  
    #2

    Apr 6, 2009, 08:09 AM

    I would take it to a Plumbing supply store they may be able to help you to find you the correct one, or call Delta again and tell them that they sent you wrong one, good luck.

    John
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #3

    Apr 7, 2009, 12:14 AM

    There used to be a company called "Valley Faucets". Their faucets and interior parts looked like Delta...

    Go to local "Mom'n'Pop's" store, or ACE hardware. They have Stem Book that will ID this stem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replace three-handle shower diverter stem [ 3 Answers ]

Do you have a diagram or schematic of the diverter stem for a three-handle shower? I removed the diverter stem OK, but I can't figure out which piece needs replacement.

Re-install Moen single handle shower handle [ 12 Answers ]

My Moen shower handle came off. I see there is a set screw at the bottom of it. The handle attaches to a plastic piece; however, you have to pull out the plastic piece from the wall to get the handle to fit over the plastic and to give the set screw something to set into. How do I pull out...

Diverter stem installation - three handle shower & tub faucet [ 4 Answers ]

The house is well over 25 years of age and I have replaced both hot and cold water valves and tub faucet without removal of bath and shower stall tiles - still look good. Purchased a diverter stem (Galtmaster tub and shower models - 1963 to 65). With the old diverter I would turn clockwise to have...

Moen Single Handle Shower Diverter Leak [ 1 Answers ]

I have a Moen single handle valve in my bathtub. The tub spout has a diverter on the top to change it to shower mode. Recently I tightened the screws on the cover plate where the handle attaches to eliminate slack which was causing the tub spout to move (and pull caulk away) each time the shower...

Removing the handle part of a shower diverter [ 2 Answers ]

I am trying to fix my leaky shower. When I turn the shower on most of the hot water goes down the drain. I have removed the screw that holds the handle on but I can't get the handle off. It will turn to the off position or to the on position. The pipe that goes into the wall will loosen but the...

View more questions Search