Ask Experts Questions for FREE Help !
Ask
    rhenekirby's Avatar
    rhenekirby Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2009, 11:21 AM
    Bryant furnace model 310 AAV/JAV
    Thought the thermostat was bad so replaced the thermostat, sounds like it clicks on but not blowing of the air, and the red light still blinks 2 shorts 4 longs, pilot light also won't come on now. Have done the swith where you turn it off for 5 minutes, still trying to troubleshoot, could use any help
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Apr 4, 2009, 01:55 PM

    On the back of the door or on the inside of your furnace should be the falt code for your 24 fault check it out and let me know what it says and I can help you. You owners manual should also have these codes
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Apr 4, 2009, 02:16 PM

    Please do as josh asked, we will need to know the diagnostic code. This will help us help you.

    Hopefully KC will be around shortly, as he is a bryant pro, and may know the code from memory.
    googler's Avatar
    googler Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Apr 6, 2009, 08:02 PM
    I had the same problem. It's a code 24. Replace the 3a fuse. When you remove the old one you will see that it has blown. Hope this helps.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Furnace model 383KAV won't kick on [ 10 Answers ]

I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...

Bryant gas furnace model 383 KAV sometimes does not run [ 6 Answers ]

I have a 10 year old Bryant gas furnace model 383 KAV that sometimes does not run. The inducer motor does not come on and there are no codes. If I cycle the power several times it will eventually all work normally at least until the next morning when it may or may not restart after being off at...

Bryant Furnace Model # 582ANW024060AAAD [ 3 Answers ]

Bryant Furnace Mode No. 582ANW024060AAAD furnace after running for about 30 min. backfires and eventually the furnace will stop while the blower continuos to run. To be able to restart the furnace you have to turn off the breaker and furnace will backfire again before it will stop. >Moved from...

Bryant Model 350MAV Furnace [ 3 Answers ]

Hi, I recently had a furnace repairman in who told me our inducer on our Bryant Model 350MAV furnace needed to be replaced. He said the total cost would be $1075.00, including $890.00 for the inducer. This seemed high to me. Can anyone give me an idea of what this repair should have cost,...

Location of the flamer sensor in a Bryant Model 383K Furnace [ 3 Answers ]

Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...

View more questions Search