Ask Experts Questions for FREE Help !
Ask
    ivan pe's Avatar
    ivan pe Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 30, 2009, 01:54 PM
    What is the process of trouble shooting any electric motor
    What is the process of trouble shooting any electric motor
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Mar 30, 2009, 02:51 PM
    YOU HAVE TO INSURE THAT THERE IS POWER GOING TO THE MOTOR
    " " " " " the capacitor is good and working
    If these 2 items are checked and all is OK,, well,it should be working, if not time to replace it
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #3

    Mar 31, 2009, 10:12 PM

    #1. Don't forget about the amp draw. Prolonged overamping will kill an electric motor

    #2. Do your own homework.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble shooting my T.V. [ 1 Answers ]

I have an older model rear projection television, the video and sound both went out at the same time, anyone have an idea on what I need to change out

Trouble shooting furnace [ 3 Answers ]

Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...

Trouble shooting [ 1 Answers ]

hi I have 1997 dodge ram 1500 4x4 my tail light went out and then the single light would . Cheeked out both. Bulbs on the right side, know the kicker is the hazzards work, the turnsignal works, if I step on the break.pleas help. Note I have replaced the turnsignal switch. still no luck.

Furnace Trouble shooting [ 1 Answers ]

I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...

Trouble shooting a/c unit [ 2 Answers ]

How do I find out if a capaciter is bad or starter on a/c unit

View more questions Search