Ask Experts Questions for FREE Help !
Ask
    Corney's Avatar
    Corney Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 31, 2009, 01:03 PM
    Installing a light to a ceiling fan.
    Installing a light to a Hunter fan, followed all instructions and wire the black to the black and white to the white.
    I does not work there is no power on these lines?
    Corney
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
    		  
    #2

    Apr 1, 2009, 07:15 PM

    What was there before the fan, how was it wired and did it work?

    Ceiling fan wiring - Ceiling Fans N More
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installing a ceiling fan light kit? [ 26 Answers ]

I have a question about adding a light kit to my ceiling fan. I've gotten it to the point where I can have the fan running by itself, and I can have the fan running with the light on, but I can't have the light on without the fan. My question is: "How can I control the light and the fan...

Installing Ceiling fan with light [ 3 Answers ]

Hi there, am after some advice on installing a ceiling fan with a light into a house that has a flat cliplock roof, so no access to the roof to install. Does this matter? Would it cost extra if I have it installed by a licensed electritian? Thanks

Installing a brand new ceiling light [ 1 Answers ]

I just moved into a condo and the living room didn't have a ceiling light. It did however, have a box pre set up with all the wires running through it. My ceiling light has two light bulbs, has two black wires, two white wires and a non-covered copper cable. In the ceiling box, there are 4...

Installing a light kit on a ceiling fan where a switch enables both fan and light [ 2 Answers ]

I have a Hampton Bay ceiling fan with three wires emerging from the top: white, black, red, and green. Presently the white, black, and green are hooked up to a switch and the fan works fine. The red is capped. The fan also has a chain which I intend on keeping on the medium setting indefinitely. ...

Installing fan and light switch for ceiling fan [ 9 Answers ]

I am trying to install a switch that controls both the ceiling fan with 3 speeds and a dimmer switch all in one unit for a hunter ceiling fan. At the wall switch there is a black wire which is always hot, a red and a ground. At the ceiling, where I removed a light fixture, there is a black, red,...

View more questions Search