Ask Experts Questions for FREE Help !
Ask
    jack3156's Avatar
    jack3156 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 29, 2009, 11:39 PM
    T-connector to angle stop
    Is it possible to connect a T-connector to the ACCOR, one piece angle stop
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #2

    Mar 30, 2009, 12:40 AM

    At what end ? At the incoming supply side or where water supply connector connects ?

    But, basically, answer is Yes, you can connect T to angle stop. If you tell us more about what you plan on doing, we can then give you more precise answer.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Mar 30, 2009, 06:01 AM
    Like Milo says, Where do you want the tee to go. On the supply from the stop or on the stubout ahead of the stop? We're waiting! Cheers, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Angle stop with PEX [ 8 Answers ]

I would like the easiest route from a standard angle stop to a copper pipe (then to PEX). This is for a toilet supply. I would like to use a standard angle stop and screw it to a copper pipe, and use Shark Bite or Watts quick-connect to connect it to the PEX. I want to avoid using another...

Hissing Angle Stop [ 1 Answers ]

We just had the angle stops for all of our toilets as well as the flushing mechanisms replaced just over 2 months ago. Now the angle stop in our master bathroom is hissing when the tank is filling back up with water. Any ideas on how to fix it? If I turn down the wate pressure, it does stop...

Installing angle-stop [ 3 Answers ]

I need to replace my angle-stops for my kitchen sink. Never done it before. It seems easy, but I want to make sure before I do it, that I'm doing it correctly. Appreciate it, in advance.

Angle stop valve [ 3 Answers ]

Do you have any idea on how to install a stop valve under a bathroom sink? Thanks R. Koehn

Angle stop [ 3 Answers ]

What is a standard 1/2" compression angle stop? I am installing a sink faucet supply line


View more questions Search