Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Leaking drain hose
[ 1 Answers ]
My drain hose that is attached to the washer and drains into the wall is leaking at the connection from the washer. How do you tighten the clamp? Is it possible I need to get a new clamp? So far I have cleaned up 2inch standing water 3 times in my laundry room. Each time I think I have it tight...
Washer hose rusted on
[ 1 Answers ]
My brother in law just bought an old house, from the 50's. As they were installing the new washer they noticed the old cold water hose was rusted on to the vavle. After numerous attempts with WD40 two pipe wrenches and two guys the thing still has not budged. In an attempt to possibly screw off...
Washer hose flow valve
[ 3 Answers ]
I just bought new washing machine connectors at a national home improvement store. They are billed as flood preventative because they have a diaphram valve at the connector which shuts down water flow when flow exceeds 2.5 gpm. However, I can only turn on the water valves less than a quarter of a...
Hose Pipe Drain - Not There
[ 5 Answers ]
I just moved into my first home. It's a new construction. I have connected my dryer, even replaced the cord because it was the wrong prongs. Now my washer has 3 tubes. I have connected the hot and cold, but there is no place for the drain pipe. Was this suppose to be in the house when it was built?... View more questions Search
|