Ask Experts Questions for FREE Help !
Ask
    dshiff's Avatar
    dshiff Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 9, 2009, 08:04 AM
    Wiring can lights on three way
    I removed a florecent light and wired three can lights on that three way switch. The casings of the cans are really hot. The other lights on single switches are fine. All wiring is okay I am lost.
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #2

    Mar 9, 2009, 06:19 PM
    Mmm..
    And the question is? I'll '' assume it's the heat that concerns you. Check the rating of the fixture. Check to see if the mfg. wants it uncovered by insulation. If your installation is proper, and you are using the proper size bulb, then you SHOULD be OK.
    But in can lighting, I would recommend cfl's over incandescent.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #3

    Mar 9, 2009, 06:49 PM
    I agree, I think there is a question in there somewhere.

    Missouri is is right on. If everything is installed properly you are fine. Recessed lighting gets hot.

    If they are IC rated cans you can ocver them with insulation. If not then NOT!

    What brand and model are the cans?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a fan with two lights [ 2 Answers ]

I have a new fan that has an upper and lower light and the fan can be controlled by two different light switches. The wiring is a follows: From the ceiling: One black, white, red and ground From the fan: One black, white, blue (lower light), orange (upper light) and ground Do I connect...

Wiring 3 lights with one hot coming in [ 4 Answers ]

I am remodeling a bath and have one wire coming in. It was used for 1 light. I want to put in a light over the vanity, an exaust fan, and an additional light. Each with its own switch. How can I do this? I am not an electrican so very simple direction would be helpful.

Wiring short in lights [ 2 Answers ]

HI, My Mother was replacing my switch plates and receptacles and touched the ground wire to a screw in the box when the electricity was on. This caused the lights to short out and shorted out the other lights on this electrical wire. The short happened at the 3-gauge plate. We have tried to reset...

Wiring lights to fan [ 1 Answers ]

I have Hunter fans, I am installing light. The fans are wired to a variable speed select switch. I connected white (marked light) and black with white tracer (marked light) The fan and light switch seem to be connected in parallel. The fan and light switch work alternating switching the fan off...

View more questions Search