Ask Experts Questions for FREE Help !
Ask
    sbattery's Avatar
    sbattery Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 5, 2009, 08:01 AM
    Well Pressure tank
    I have a flotec tank. What is the torque for the bladder?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Mar 5, 2009, 03:07 PM

    Torque for the bladder? Do you mean what pressure the tank is to be set at? If so, it will be 2# below the cut in pressure for the switch. Perhaps I'm not understanding your question.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pressure/bladder tank losing pressure? [ 11 Answers ]

Well, I have asked some questions about my plumbing before. So I am calling on you guys once again. I have a 52 gallon pressure tank/bladder tank made by wellsaver. I turn the water on and have good pressure for a few minutes then it basically goes dead with no pressure. I recently posted questions...

Bigger pressure tank or increase pressure? [ 5 Answers ]

I bought a new home and the builder had installed a 20 gal pressure tank. I have a jet pump system where the motor sits directly on the tank itself. I really notice the pump running a bit,but also notice the loss of pressure quickly, especially in the shower. Now I was thinking of buying a much...

Loss of water pressure w/new pressure tank [ 8 Answers ]

Hello everyone, I have a question involving my plumbing. I was having terrible water pressure and I checked the pressure at the pump itself and it was great. Went to the pressure tank and it was trickling. Shut down power to pump and drained system - checked air pressure and it was not...

Deep well, pressure tank/switch not building pressure [ 13 Answers ]

The only way I have water pressure is to leave the power on! I have replaced the 5 gallon pressure tank (28psi when void of water)/fittings/pressure gauge and tried 3 new 30/50 pressure switches and the problem remains the same. With the power off, the pressure drops to 0 (not 30). When I...

Tank Pressure vs Pump Cut Out Pressure for Well [ 1 Answers ]

I am trying to increase my water system pressure to the minimum required 40 PSI to feed my reverse osmosis drinking water filter. However, the 33 gallon pressure tank for my well pump system says it is pre-charged at 30 PSI and that the cut in pressure for my pump should be set equal to that 30...

View more questions Search