Ask Experts Questions for FREE Help !
Ask
    davills's Avatar
    davills Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 5, 2009, 01:51 PM
    Miller furnace with 3 red flashes
    I have a miller mobile home furnace about 11 years old... I have been having problems with it not "kicking" in no matter what I have the heat set at. Now it won't start at all. The error code is three red flashes. What does that mean?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Mar 5, 2009, 02:19 PM
    I believe 3 flashes is a fault related to the pressure switch. Look on the panels (inside too) and the main control board for a legend describing the codes.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Miller Oil Furnace [ 3 Answers ]

I have a miller oil furnace that was installed in July of 2006 it has been running just fine until now I have power to it but it won't run. I can get the fan to start but when I hit the reset button all I get is the blinking light. Can you help:(

Miller furnace [ 1 Answers ]

I have no pilot light. The burner lights on full capacity at all times.

Miller oil Furnace [ 10 Answers ]

The light on the reset button keep flashing saying that it is locked out how can it be unlocked

Miller furnace [ 1 Answers ]

I have a miller furnace. It runs on LP gas. It comes on the ignitor comes on the burners see to light but the blower won't come on. Is this the mother board? I have replaced this in the past. The ignitor was burned out and I replaced it. I still can't get the blower to come on.

View more questions Search