Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Dialing in a footing to to build a wall to close in an existing attached garage
[ 1 Answers ]
I'm in nc an inspector called me and told me to dial in a footing where I'm going to build a wall. I might drill about 8 two foot long rods into the existing 18' long footing then lay two #5 continuous rods tied to the rebars. Put some visqueen down. Here in oxford nc carolina they want the footing...
How much does it cost to tear down/replace a wall?
[ 1 Answers ]
I would like to knock down two walls from the kitchen to create a "great room" effect. I would like to join the living, dining and kitchen together but a friend advises that just this portion of the project will run well into 50k, which is my budget for remodeling the entire house! Does drywall,...
How long must a garage pad cure before you can build on it?
[ 1 Answers ]
Once you have your garage pad poured, how long do you have to wait before you start framing your garage? Thanks, lbrowne
Build a Universal Garage Door Opener
[ 1 Answers ]
Hello - not sure I'm posting to the right forum, but I couldn't find anything that was a closer fit. Basically, what I'm looking for is information about frequencies and datastream formats for automatic garage door systems. Yes, I'm completely aware that there are LOTS of cheap universal garage... View more questions Search
|