Ask Experts Questions for FREE Help !
Ask
    Denise M's Avatar
    Denise M Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 8, 2008, 12:54 PM
    Furnace blowing cool air through vents
    The other night my husband had turned the heat way up because he was cold. I turned it down because it was too hot. Ever since then I turn the thermostat up and select it to heat to 75 , but all the vents blow is cool air and the thermostat stays at 67 or 68 degrees. It is a programmable thermostat, but I have reset the programs all for 75 degrees, but it never gets past 68. What could be the problem??
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 8, 2008, 03:00 PM
    First question is the furnace heating at all or just blowing air around?
    Type of furnace? Gas,oil,electric,heat pump?
    mickeyjo34's Avatar
    mickeyjo34 Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Mar 2, 2009, 07:14 PM
    It could be the heat sequencer or the heat strips. As we had this problem as part of our difficulty too...
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Mar 3, 2009, 03:34 AM
    This question is 4 months old. I hope they have there heat fixed by now.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #5

    Mar 3, 2009, 04:45 AM
    You've been slightly AWOL. Some of us were getting concerned. A search party was forming.:rolleyes:
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #6

    Mar 3, 2009, 05:35 AM
    Too much is going as usual but it got a bit out of control. LOL
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace barely blowing cool air [ 4 Answers ]

Hi,I have a concord 80 plus furnace installed in 2002... Everything is kicking on the fan turns on, the igniter ignites the gas , and a minute or so later the blower comes on... problem is the air is cool and barely blowing?? all vents are open correctly... cold air return is working fine... filter...

Furnace blowing cool air [ 4 Answers ]

I have a Trane XL80 furnace, the past couple weeks I have had blower running but no heat. System shows 2 flashes: System Lockout (No flame) check line polarity. If I shut off switch (by fuse) then turn back on, it will ignite (but might take a couple ignites, if after 5 X's and burners do not stay...

Furnace blowing cool air [ 2 Answers ]

A Goodman furnace was recently installed in the flat that I rent. The problem is it is going on and off 24/7 and during it's cycle it goes like this: furnace starts up for about 20 seconds, the gas jets ignite for another 20 seconds, then blower turns on and begins to first blow cool air for...

Furnace blowing cool air [ 3 Answers ]

I have a Bryant gas furnace. About 2 days ago it was working fine. Yesterday I noticed it was very cool in my house. I checked the vents and they were blowing cool air. The fan stays on continuously. The pilot is lit and the filter is new. What are some possible causes and solutions to this...

View more questions Search